Guide · 4 min read
Tap thread and size guide
A nozzle has to match the thread at the mouth of your tap. Two minutes with a ruler – or a photo on WhatsApp – saves ordering the wrong one.
Step 1: Is there a removable aerator?
Look at the mouth of the tap. If there is a small cap you can unscrew by hand, the tap is threaded and can take a nozzle. If the tap has no thread, or the aerator is concealed (built into the spout), a screw-on nozzle will not fit.
Step 2: Inner or outer thread?
Unscrew the aerator. If the thread is on the inside of the tap mouth, it is a female (F) thread. If it is on the outside, it is a male (M) thread.
Step 3: Measure the diameter
Hold a ruler across the tap mouth, or measure the aerator you removed. Then match it to the table below.
| Thread | What it means | Nozzles that fit |
|---|---|---|
| F24 | Inner thread, about 24 mm | TrueMist Twister (adapter), Atomizer, TrueSpray, True Tap Shower |
| M24 | Outer thread – the standard 22 mm Indian tap | Atomizer, TrueSpray, True Tap Shower |
| M22 | Outer thread, about 22 mm | TrueMist Twister (adapter) |
| F20 | Inner thread, about 20 mm | TrueMist Twister (adapter) |
| F18 | Inner thread, about 18 mm | TrueMist 500, TrueMist Twister (adapter) |
| Aerator socket 20.8 / 18.1 / 15 mm | Standard, Junior and Tom Thumb sockets | Altered:Nozzle (adapters in pack), Dual-Flow PRO |
Thread names vary between makers. If your measurement falls between sizes, send us a photo – include a coin or ruler for scale.
Step 4: Check the pressure
Most homes with an overhead tank have low pressure; homes with a booster pump can have more than 2.5 bar at the tap. Note which you have – it decides between some models.
Fitting questions
How do I find out the size of my tap?
Hold a measuring scale under the tap and measure the outlet diameter, or remove the aerator or adapter ring and measure the thread. Our tap thread guide walks you through it.
Can I use a water saving nozzle on a tap without a thread?
No. The nozzles screw onto the tap's aerator thread, so taps without a thread cannot take them.
My tap has a concealed (cache) aerator. Will a nozzle fit?
Unfortunately not. You need a tap with a detachable socket for a removable aerator.
Does it fit my existing tap?
Most threaded taps, yes. TrueMist Twister ships with adapters for F24, M22, F18 and F20 threads; Altered:Nozzle ships with adapters for Standard (20.8 mm), Junior (18.1 mm) and Tom Thumb (15 mm) sockets; TrueSpray, True Tap Shower and Atomizer fit the standard 22 mm M24/F24 tap.
